toobinator wrote:If you have your sonar charts installed on your Navionics, this is what you do.
With the unit on (of course) press the menu button twice. This will bring up the main menu.
Go to the charts tab, scroll down to maps. I think that's what it's called, going from memory here.
Scroll down to chart, it will say auto.
Press the cursor to the right until it says Fish 'n chip. It might say left or right Fish 'n chip, depending which slot you have the Navionics in.
Press exit until you are out of the menus. It'll take a few seconds to load, but your 1' intervals should come up.
If the chart tab doesn't show up, then go to set-up. Scan down until it says operator mode (or something like that) change it from normal to advanced then go back to the above.
Ed
Could not find "Maps" in Charts tab. I tried looking at a few things....screwed some things up and managed to get most fixed LOL!!!
My selections and settings under the CHART tab are as follows:
CHARTS
Lat/Lon Grid - Visible
Navaids On Birds Eye View - Visible
Set Simulation Position
Set Map Offset
Shaded Depth - 16ft.
Chart Detail Level - All
Map Borders - All Visible
Spot Soundings - Visible
Auto Zoom - Off
Auto Range - Off
Vessel Offset - Off
Offset Speed - 9kph