I have a 10" HT polar thermal tip-up and a 10" ice auger.Therefore, the tip-up falls thru the drilled hole.
So,my ? is ,how do I correct this problem without having to purchase a smaller diameter bit ?
Correcting a problem
Correcting a problem
As the fish say
"DROP ME A LINE"
Mark
"DROP ME A LINE"
Mark
- DropShot’r
- Bronze Participant
- Posts: 155
- Joined: Wed May 15, 2013 7:19 am
- Location: Beautiful Ontario....
- Happy Hooker
- Participant
- Posts: 97
- Joined: Wed May 05, 2004 5:27 pm
- Location: Ottawa
Re: Correcting a problem
Buy yourself a 1x6 cut to width required, drill hole in center to allow line and tip-up shaft to go threw and you got a tip-up that will span the hole.
Have a good one.
Happy Hooker
Have a good one.
Happy Hooker