Broken Evinrude in Cobden

This is where it's all going on. One can ask for advice or general information or simply chew the fat about fishing tackle, tips, and locations.
Post Reply
User avatar
jet
Participant
Participant
Posts: 11
Joined: Wed Jun 02, 2004 12:41 am
Location: PA

Broken Evinrude in Cobden

Post by jet »

Looking for service or ideas. Evinrude 50hp jet with no spark. Did check kill switch. Ran fine until the trip here. Trying not to ruin my week. Anyone heard of a place called Plummers? Checked all wires and fuses. Cranks fine. Thanks so much. Jet
User avatar
cornplanter2
Participant
Participant
Posts: 78
Joined: Thu Mar 10, 2005 10:02 pm
Location: Stittsville

Post by cornplanter2 »

Plummers is at Pembroke.
Foy's marina would be closer to you, it is just outside Renfrew on Highway 60 going toward eganville
User avatar
troutnmuskiehunter
Diamond Participant
Diamond Participant
Posts: 3131
Joined: Wed Feb 28, 2007 11:30 am

Post by troutnmuskiehunter »

George's Marine is closer for you and they would be more likely to have stocked parts as opposed to a smaller outfit....

Go down Main St in Cobden and get onto the Cobden Rd which eventually turns into HWY 60...go through the towm of Eganville and Georges is a few miles outside of town on the right hand side....you can't miss it!!!
User avatar
jet
Participant
Participant
Posts: 11
Joined: Wed Jun 02, 2004 12:41 am
Location: PA

Post by jet »

This is really helpful info. Thanks so much! Anyone had a motor act like this?

Tournament here today. Fishing poor. Rained everyday in June except 3 according to locals. Muskrat is murky. Thanks again everyone. Jet
User avatar
steely5
Participant
Participant
Posts: 40
Joined: Wed May 05, 2004 4:48 am
Location: Marionville Ont

broke motor

Post by steely5 »

I have a 97 johnson 50.did the same thing on the StLawrence.Had to replace power box on the other side of engine from throttle links ,Little black box about 3 inch by 3 inch with a bunch of wires going to it.very easy to replace,as for cost don't know it was under warranty at the time.Hope this helps good luck
Post Reply