Page 1 of 1
Broken Evinrude in Cobden
Posted: Sun Jun 29, 2008 7:54 am
by jet
Looking for service or ideas. Evinrude 50hp jet with no spark. Did check kill switch. Ran fine until the trip here. Trying not to ruin my week. Anyone heard of a place called Plummers? Checked all wires and fuses. Cranks fine. Thanks so much. Jet
Posted: Sun Jun 29, 2008 9:24 am
by cornplanter2
Plummers is at Pembroke.
Foy's marina would be closer to you, it is just outside Renfrew on Highway 60 going toward eganville
Posted: Sun Jun 29, 2008 10:27 am
by troutnmuskiehunter
George's Marine is closer for you and they would be more likely to have stocked parts as opposed to a smaller outfit....
Go down Main St in Cobden and get onto the Cobden Rd which eventually turns into HWY 60...go through the towm of Eganville and Georges is a few miles outside of town on the right hand side....you can't miss it!!!
Posted: Sun Jun 29, 2008 4:43 pm
by jet
This is really helpful info. Thanks so much! Anyone had a motor act like this?
Tournament here today. Fishing poor. Rained everyday in June except 3 according to locals. Muskrat is murky. Thanks again everyone. Jet
broke motor
Posted: Mon Jun 30, 2008 4:48 am
by steely5
I have a 97 johnson 50.did the same thing on the StLawrence.Had to replace power box on the other side of engine from throttle links ,Little black box about 3 inch by 3 inch with a bunch of wires going to it.very easy to replace,as for cost don't know it was under warranty at the time.Hope this helps good luck