Fish-Hawk.Net

Hi Folks,

I went to installl my new Easi-Troll hs today and hit a snag. I have a Lund WC 14 and when I set it where it needs to go the wire that holds the ball rubs against the top rail of the boat.

I have the swivel mount for it and when I swivel it back one click it seems to just clear the boat.

I am really hoping that somone has a good solution for this as I want to install it over the week-end.

Thanks
High Noon

i have noticed that some people with utilities use a board. they run a board across from one side to the other and hold it down running a bolt down through the oar lock.

High Noon,

How/where did you mount your swivel base to? Canon sells a pedestal base that gives you 6" more height....that would resolve your problem..check with LeBarons or some of the local shops, they may have them in stock.

http://www.cabelas.com/cabelas/en/templ ... hasJS=true

Hey Highnoon

Had the same problem. Go to Home Depot and get a 2 X 6 and cut two sections or three if you want it hogher. Bolt them and the mount to wherever you are going to mount it and you're done. Much cheaper than a Cannon mount.

Billy Bones

billy not a bad idea if your putting it on your wifes car
man this is his boat . think about it

hooker

hooker wrote:billy not a bad idea if your putting it on your wifes car
man this is his boat . think about it

hooker

Hey Hooker

I used this method when I built a storage area in the back of my boat to conceal the batteries and the gas tank. Storage area also has a
pedestal seat mount. Covered the solid pedestals with indoor/outdoor carpeting to make them more pleasing to the eye. Mounted
two Cannon Mini Mags, looks and works great.

Billy Bones

to each there own i like stuff done right just me

You're not alone Hooker....I'm the same as you...