seems to be highly effective for all other trout..

Berkley Gulp Alive 2.5" minnow, shad color? Those work well for just about any fish..Out4trout wrote:They might work, however, there are much better baits available. Although small lake trout feed on daphnia etc, most lake trout > 4lb are primarily piscivorous.
For that reason, minnow or shad imitation baits such as silver spoons, white tubes or jointed rapalas tend to be on the end of my line when hunting lakers.
Good choice, or upsize to 3.5" Gulps. Go out during flat water, a slight wind is fine, you can cover more area without paddling. A drift sock would also help slow your drift.ChrisCool wrote:Berkley Gulp Alive 2.5" minnow, shad color? Those work well for just about any fish..
I have a 17' long sea kayak.. not really meant for fishing.. How can I fish lake-trout out of that?
If you want Lakers from shore, first you need access to deeper water within casting distance. Best bait would be whole Cisco( herring), large Smelt, large suckers, or possibly even smaller Mackerel from the grocery store. The best rig I've used is those gorge hook outfits with the dual hook, steel leader and a baiting needle. Thread it through the mouth and out the tail meat. These have worked well for us off the dock on Pemichangan until the middle of June when the water is warming up and they move to deeper water. If you were to find a nice point sticking into deeper water they would still work fine. Lakers tend to pick it up and run a bit first, then drop it and take it head first, so your best bet is to set the hook on the second run.ChrisCool wrote:How about a worm sitting on the bottom?
(casting a line out from shore into deep water, and let it stay a few inches off the bottom) Are lake trout likely to bite?
Do you use a slip bobber with those?smitty55 wrote:If you want Lakers from shore, first you need access to deeper water within casting distance. Best bait would be whole Cisco( herring), large Smelt, large suckers, or possibly even smaller Mackerel from the grocery store. The best rig I've used is those gorge hook outfits with the dual hook, steel leader and a baiting needle. Thread it through the mouth and out the tail meat. These have worked well for us off the dock on Pemichangan until the middle of June when the water is warming up and they move to deeper water. If you were to find a nice point sticking into deeper water they would still work fine. Lakers tend to pick it up and run a bit first, then drop it and take it head first, so your best bet is to set the hook on the second run.ChrisCool wrote:How about a worm sitting on the bottom?
(casting a line out from shore into deep water, and let it stay a few inches off the bottom) Are lake trout likely to bite?
Cheers
Nope, strictly bottom fishing. If you have a boat you can also use multiple rigs on the same line as well.Thread 2 of them on the line through the loop and hook one to a swivel on the end of the line like normal. With someone holding the rod on shore venture out with the boat. Drop the first bait on the surface at lets say 45 feet, the second slider at 60 feet, and then the last one at the end of your line at 80 feet. Then let go of the line and all three will drop together at their designated depth. Go back to shore, have a seat and relax. Of course the same thing can be done with just the single bait to bring it to the exact spot you want if it's not within casting range. It used to be a quite common method for early Laker fishing on the Quebec side. The channel on Pemich was very well known for this until those cottage/homes were built. Now most just anchor in the channel. It can be quite busy opening weekends for sure.scarkner wrote: Do you use a slip bobber with those?